Shaft Rotor Shaft Assembly Shaft & Rotor Assembly machine This new semi-automatic machine will be used for Pressing the shaft into rotor as per requirement and spot facing, center drilling, drilling, reaming, cleaning the hole and pin pressing into hole the process sequence of this requirement • Shaft pressing into Rotor – The operator loads the rotor and shaft, and after part detection, pressing begins, with load confirmation displayed. • Shaft rotor height checking gauge – The operator checks the part's height, and the machine confirms with a green light. • Part loading at SPM – The operator loads the part, and after orientation and mix-up checks, the machine indexes to the next station. • Spot facing Operation – The tool performs spot facing under servo control, coolant is applied, and a sensor checks tool condition. • Center Drilling Operation – The center drilling tool operates under servo control, with coolant applied and tool condition monitored. • Drilling Operation – Drilling is servo-controlled with coolant, and a sensor checks tool condition after each cycle. • Reaming Operation – Reaming is servo-controlled with coolant, and tool condition is checked by a sensor after each cycle. • Cleaning of hole – Air pipes clean the reamed hole by blowing out chips and coolant. • Pin Pressing – The pin is pressed into the hole, with load monitoring, and the part moves to the next station after confirmation. • Pin height checking and unloading – Pin height is checked, and the part is unloaded using a pneumatic magnet after confirmation.